The Do’s and Don’ts of Quarter Round Tile Trim Installation

Quarter round tile trim is a versatile and elegant way to finish the edges of your tiled surfaces. It can be used to create a seamless transition between the tile and the wall or to provide a decorative accent. However, installing quarter round tile trim can be tricky, so it’s important to follow the proper steps. Here are the do’s and don’ts of quarter round tile trim installation:

The Do’s

1. Cut the trim to the correct length.

Measure the length of the area where you will be installing the trim and cut it to size using a wet saw or a tile cutter. Make sure the cut is clean and straight.

2. Apply thinset to the back of the trim.

Use a notched trowel to apply a thin layer of thinset to the back of the trim. Press the trim into place, making sure that it is level and flush with the edge of the tile.

3. Grout the trim.

Once the thinset has dried, apply grout to the joints between the trim and the tile. Use a grout float to press the grout into the joints and remove any excess.

4. Seal the trim.

Once the grout has dried, apply a sealant to the trim to protect it from moisture and stains.

The Don’ts

1. Don’t use too much thinset.

Applying too much thinset can cause the trim to sag or fall off. Use a thin layer of thinset and press the trim into place firmly.

2. Don’t cut the trim too short.

If the trim is too short, it will not cover the edge of the tile and will look unfinished. Make sure the trim is cut to the correct length before installing it.

3. Don’t grout the trim too soon.

The thinset needs to dry completely before you grout the trim. If you grout the trim too soon, the grout will not adhere properly and could crack or fall out.

4. Don’t seal the trim too soon.

The grout needs to dry completely before you seal the trim. If you seal the trim too soon, the sealant will not adhere properly and could peel off.

By following these do’s and don’ts, you can ensure a successful quarter round tile trim installation.